PIC16F72-I/ML【PDF 5/136 页】IC PIC MCU FLASH 2KX14 28-QFN

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录3871

1页 2页 3页 4页 [5页]6页 7页 8页 9页

102

2535J–AVR–08/10

ATtiny13

17. Memory Programming

This section describes how ATtiny13 memories can be programmed.

17.1 Program And Data Memory Lock Bits

ATtiny13 provides two lock bits which can be left unprogrammed (“1”) or can be programmed

(“0”) to obtain the additional security listed in Table 17-2 on page 102. The lock bits can be

erased to “1” with the Chip Erase command, only.

Program memory can be read out via the debugWIRE interface when the DWEN fuse is pro-

grammed, even if the lock bits are set. Thus, when lock bit security is required, debugWIRE

should always be disabled by clearing the DWEN fuse.

Note:

1. “1” means unprogrammed, “0” means programmed

Notes: 1. Program fuse bits before lock bits. See section “Fuse Bytes” on page 103.

2. “1” means unprogrammed, “0” means programmed

Table 17-1.

Lock Bit Byte

Lock Bit Byte

Bit No

Description

Default Value (1)

–

1 (unprogrammed)

–

1 (unprogrammed)

–

1 (unprogrammed)

–

1 (unprogrammed)

–

1 (unprogrammed)

–

1 (unprogrammed)

LB2

Lock bit

1 (unprogrammed)

LB1

Lock bit

1 (unprogrammed)

Table 17-2.

Lock Bit Protection Modes

Memory Lock Bits (1) (2)

Protection Type

LB Mode

LB2

LB1

No memory lock features enabled.

Further programming of the Flash and EEPROM is disabled in

High-voltage and Serial Programming mode. Fuse bits are

locked in both Serial and High-voltage Programming mode.

debugWire is disabled.

Further programming and verification of the Flash and

EEPROM is disabled in High-voltage and Serial Programming

mode. Fuse bits are locked in both Serial and High-voltage

Programming mode. debugWire is disabled.

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式